SMD vs. NSMD

In general, we and just about everyone else on the planet recommend NSMD (non solder mask defined) pads for your BGA land. Using copper to define the land gives more precision than using solder mask and, more importantly, gives a more reliable solder joint.

BGA on HASL close with vias between pads There are a few cases where SMD (solder mask defined) pads might be more appropriate. The Beagleboard folks, with their 0.4mm pitch Ti OMAP processor found that at that small a pitch, NSMD pads increased the chances of bridging.

Interestingly, IPC writes that the main advantage of SMD pads is to prevent pad lifting. They further note that since the corner balls are most likely to have lift issues, due to the greater concentration of stresses. If you have concerns about corner pad lifting, you might want to use SMD pads just in the corner for a little extra holding power. (ref IPC-7095B, 6.2.2)

Duane Benson
Danger! 50,000 Ohms

http://blog.screamingcircuits.com/

One thought on “SMD vs. NSMD

  1. Pingback: Questions on SMD and NSMD at Circuits Assembly blog

Comments are closed.