It’s not quite grape power, but over in the Microchip booth, the EverReady folks were handing out little digital clock demos. Nothing sounds the least bit interesting about that, except what they’re really showcasing is a little Microchip step-up DC-DC converter, the MCP1640. They’re using that little chip and an Energizer 1.5V AAAA cell to power the chip at 3.3 volts.
Looking a little closer, it’s a PIC16LF1933. On the other side of the battery, there’s a set of six unpopulated pads labeled J1. I’m guessing that’s the ICSP port. I do have MPLAB on my laptop here and I have my hand, dandy PicKit 3 with me as well. What I don’t have with me is a soldering iron and a spare header … Actually, now that I think about it, I do have some six-pin headers down here with me. I might be able to put in into the PicKit and then just hold it tight to the solder pads. I’ll probably sleep tonight though instead of staying up and writing something fun for this to do. I’d probably spend most of the night just trying to get the fuse bits figured out. A project for another day.
It’s a little big to strap on my wrist
keep a small butane powered soldering iron with you…you will find hundreds of uses and be the hero…