Components So Fragile, They Break Before Arrival

There are a lot of components that require special handling. Some days, “special” requirements seem more the norm than the exception. But, every now and then, we see something that puts even those special components to shame.

Not long ago, we received a parts kit that contained a component so fragile, that most of them didn’t survive the trip with the shipper. It’s a 10 x 9mm (well, actually 9.68 +0.00/- 0.08mm x 8.64 +0.00/- 0.08mm, to be precise) sensor that’s only 0.05mm thick. That’s 1/4 as thick as the diameter of the solder balls connecting it to the PCB.

The part has solder balls on the silicon, with no other packaging. The dice has to be that thin, as the light-sensitive area is on the other side. That doesn’t make for a very robust component. It would require special handling all around. Unfortunately, no matter how careful we might be, if they’re broken when we receive them, there’s not much we can do (other than take pretty pictures).

In taking these closeups, I noticed that the registration in ball placement isn’t all that great. In the image below, take a look at the ball on the left, second from the bottom, and the ball on the far right.

The datasheets call out all non-specified tolerances as +/-0.001mm. With these being 0.2mm diameter solder balls, I’d have to say this is way outside of that tolerance. I’m sure the part would have adhered to a decent board just fine, but if the PCB were off a similar amount in the opposite direction, you may very well have a problem.

 

Duane Benson
You could make a very tiny sundial out of this.
But, could you use the shadow parallax to calculate the distance to the sun?

http://blog.screamingcircuits.com